The reset method of Brother printers
Last week, we have purchased the brother tn 660 from the manufacturer V4ink. Their workers also have told many things need to be noted about the printer. They said we should shock plus powder cleared must be carried out before the alarm, or even cleared can not take long. It is best to take advantage of a lot of powder to clear, diligently, ground clear zero

Brother printer reset method:
1, the boot case, remove the brother cartridge or drum unit, flat on the desktop, on the right there is a small square This is where the authorities.

2, the toner alarm is certainly at the bottom of the slider, and now carefully with a flat-head screwdriver deep into the gap below the slider, try to turn the screwdriver, leverage the lever pry, slowly by feeling hard, you will listen To the dah sound, the slider is lifted. In a click, the final slider is pushed to the top along the path shown by the curved arrow.Now put the drum unit into the machine, close the front cover, the machine self-test, the yellow Toner light is no longer flashing, indicating that the counter has been cleared. For verification, I printed the machine settings page before and after clearing (quick and continuous press of Go button).

3, to see Toner bar shows that from zero into full, and the color of the print is also deeper, indicating that the machine that full of toner powder. With this method can squeeze the last powder, until completely powder-free powder.From the above settings page you can see, cartridge life will be counted, that DRUM bar is empty, the machine prompts to replace the cartridge, and refused to work. The old print cartridge can still be used, but the print cartridge counter must be cleared as follows:Turn on the front cover, hold the GO key (in this case, the front cover has been opened, you must hold the white button inside the machine, as shown in the circle below), for about 4 seconds, the three lights on the panel Turn on, turn off at the same time, then let go.

4, and then remove the drum unit, then re-load the machine, close the front cover, the machine self-test, complete reset. Press the GO key three times in quick succession to print the setup page, and you can see that the cartridge (DRUM) is full.